Modification list:
1. Installed Bondtech dual gear clone with stepper motor- improve the process of filament feeding.
2. Replaced the stock springs with silicone spacers-help to hold the bed level longer than springs.
3. Made extended arm and mounted it on the side, since the spool holder for filament on top was always pulling filament on at sharp angle through the extruder.In addition,film is pulled in the extruder much easier without grinding against he entry hole.
4. Alex firmware. With it the bed leveling is much more simple and accurate ( use the manual mesh leveling 3X3). The E steps and other calibrations are much easier to do.
5. Vertical LCd mount and custom colour scheme.
6. Remixed cooling shroud to fit 4010 or 4020 hot end cooling fan. Added second part cooling fan.
7. Adjusted voltage on steppers.Now the steppers are a bit louder but do not run so hot which it is important.

Modifications:all metal hotend,Dual Z,5015 Part cooling fan,a magnetic PEI Sheet,tougher bed leveling springs,rubber V slot covers in black, Satsana fan shroud,filament sensor from the old Z end stop,adjustable screen mount and spacer for the adjustable screen,tool spool holder,light holder,etc.,most of the STL file is from thingiverse.

Modification list:
1. flashed the firmware to Alex's firmware.
2. Extended the X400 Y400 Z450.
3. Added LED strip light.
4. Added duel Z motor because of the size of this thing .
5. Aluminium extrusion slot fillers.

Modification list:
1. full printed cable chain.
2. extruder knob.
3. slot covers.
4. BrissFang shroud.
5. Pi Zero 2 W case.
6. vertical adjustable screen mount.
7. filament roller guide.
8. feet risers.
9. motherboard and PSU fan shrouds to accommodate larger fans.
10. filament dryer top mounts,etc..

Modification list:
1. Updated firmware.
2. Satsana shroud.
3. Carry handle.
4. Full size sd card reader.
5. Fedorastruder v2.0.
6. Side mount spool holder.
7. Adjustable screen mount.
8. Tool caddy.
9. Tool drawers.
10. Hot end drag chain.
11. Isolation feet.
12. Upraded hot end cooling fan,main board cooling fan,power supply.
13. cooling fan.
14. Upgraded tension knobs.
15. Added magnetic hot bed.
16. Hot end washer hack.
17. Upgraded bed springs.

Modification list:
1. Riser feet.
2. toolbox.
3. filament roller feed system.
4. Satsana shroud and winsinn fans.
5. psu cover removed and metal shroud ventilated with quieter fan.
6. V slot covers.
7. aquarium light.

Modification list:
1. Bearing filament guide. The spool is on top of the gantry and this takes pressure off the filament runout sensor.
2. Locking bed leveling wheels. Yellow springs is also added.
3. V slot covers. Keeps dirt and filament debris out of the channels.
4. Metal extruder. One of the best functional mods you can do.
5. Feet risers. Lets some air under the printer.
Satsana duct. Way better bridges even with stock fans on it still.
Everything was printed out of uv reactive filament so it glows under a blacklight.